CNC Indexing & Feeding Technologies presents the TRACER Series of Hydrodynamic Magazine Bar Feeders for both fixed headstock and sliding headstock CNC lathes. The TRACER Minibar Hydrodynamic Magazine Bar Feeder is an economically priced 12’ bar feeder that can be used on both fixed headstock and sliding headstock CNC lathes. Specially designed to run material from .8mm to 12mm bar with the same quality and reliability you come to expect from the TRACER series. The TRACER 20 model is a high quality economical bar feeder designed for bar diameters of 26mm (1.02”) and smaller, and is available in 6’ and 12’ bar lengths. The TRACER V series can handle small bar diameters too, but is primarily designed for bar diameters ranging from 5mm (0.196″) to 80mm (3.149”). The TRACER 32V and 51V are available in both 6’ and 12’ bar lengths, while the TRACER 65V/80V is available in 12′ only. The 65V/80V is designed for bar diameters ranging from 21mm to 65mm, however, with a simple channel set change, the bar feeder will handle up to 80mm bar diameter.